Wavetronix Click 500 (programmable controller) (CLK-500) - Quick-reference Guide - Manual

Click 500
DEVELOPER QUICK-REFERENCE GUIDE
2
Install Dynamic C
1 Go to www.rabbit.com/support/downloads/dc/dc10.shtml. The Click 500 example code and applica-
tions have been tested with Dynamic C version 10.40 (it may also work with newer versions).
2 Follow the online instructions to download the installation software package and complete the installa-
tion process.
3 Run the installer program (usually named something close to “DynamicC_10.40_WebFull.exe”).
www.wavetronix.com
801.734.7200
1
Install the Click 500 software package
The Click 500 software package contains the Click 500 libraries, ex-
ample source code, and application binary code. Download the Click
500 software package by following these steps:
1 Go to www.wavetronix.com and click on the Support tab.
2 Select Click from the Start by drop-down menu and then select
Click 500 from the list that appears.
3 Click on the Click 500 Software Package in the list of down-
loads that appears. Follow the instructions to download it to
your computer.
When you have the compressed file, simply decompress it into a direc-
tory of your choosing.
Introduction
This guide will introduce you to developing a custom Click 500 application. It will cover how to mount the
Click 500, how to connect it to your computer, how to install necessary software and how to compile and
load a simple programming example. For more detailed development instructions, please see the Click 500
Developer Guide.
The guide assumes you have a way to power the Click 500. This must be done by providing power to a T-bus
that the Click 500 is mounted on. Such a T-bus, and a desktop stand for putting it on, can be obtained by
purchasing the Click Desktop Kit. You could also buy the Click 500 Development Bundle, which combines
the Desktop Kit and the Click 500 Development Add-on. If you already have the equipment to power your
Click 500, you won’t need to purchase anything else.