Wavetronix Click 400 (900 MHz radio) (CLK-400) - User Guide - Manual (Page 57)

56 CHAPTER 7 • CLICK 101
Figure 7.5 – Expert Driver General Tab
Setting Description
Module Allows you to enter a name and description of the device.
Driver Names the driver you are currently working with.
Description Shows a description of the device being configured. This is only for
your information and does not affect the operation of the device.
Location Displays the location of the device being configured. This is only for
your information and does not affect the operation of the device.
Serial # Displays the serial number of your device.
Firmware Version Shows the version of firmware your device currently has installed. If
Click Supervisor detects a discrepancy between this version and the
most current version it currently has access to, you will be prompted
to upgrade when you connect to the device.
Subnet ID Shows the subnet ID number. This option is currently not available.
Device ID Gives the ID number of the device being configured, which is used
to identify the device when you are connecting to it. By default, this
number is the last five digits of the serial number, which can be found
under the About tab or on the barcode sticker on the bottom of the
device. It is recommended that you do not change this number unless
another device on your network has the same ID number.
Table 7.2 – Expert Driver General Tab
The System > Comm tab allows you to configure how the Click device communicates (see
Figure 7.6 and Table 7.3).