Wavetronix Click 400 (900 MHz radio) (CLK-400) - User Guide - Manual (Page 70)

CHAPTER 4 • CLICK 104 69
Press and release Configuration parameter selected;
autobaud commences (will show
intermediate LED states); auto-
baud finishes and normal operation
resumes
Table 8.3 – Menu Operation Example
Inactivity of one minute on the mode switch will exit menu mode.
Front Panel Menu Options
The following figure documents the menu and configuration options available from the
front panel menu. This label is also printed on the side of the device.
Input Mapping
Menu LEDs
Cancel
1-4
5-8
9-12
13-16
17-20
21-24
25-28
29-32
33-36
1 2 3 4
R B G Y
Rotary
Switch
= SW 0
= 1-4
= 5-8
= 9-12
= 13-16
= 17-20
= 21-24
= 25-28
= 29-32
= 33-36 1
2
3
4
5
6
7
8
9
Bus 1 Baud Rate
R B G Y
Menu LEDs
Cancel
9600
19200
38400
57600
1 2 3 4
Bus 2 Baud Rate
R B G Y
Menu LEDs
Cancel
9600
19200
38400
57600
1 2 3 4
Autobaud
R B G Y
Menu LEDs
Cancel
Bus 1
Bus 2
1 2 3 4
Reset to Default
= LED Off
= LED Flashing
= LED On
R B G Y
Menu LEDs
Cancel
Reset
1 2 3 4
Menu Operation •
PUSH and HOLD Mode Switch to
cycle through menus and options.
•
PUSH and
RELEASE
Mode Switch
to make
selections.
•
1 minute of
inactivity exits
menu.
5 4 3 2 1
09
8 7
6
Figure 8.5 – Front Panel Menu Label
The menu options are displayed on the Level 1 LEDs (multicolored) and the configuration
parameters are displayed on the Level 2 LEDs (all red).
Channel Input Map
The first configuration parameter that comes up when you’re cycling through the front
panel menu is the channel input map. To select this parameter, release the push-button
when the blue LED flashes.