beautypg.com

Physical features, Communication ports – Wavetronix Click 400 (900 MHz radio) (CLK-400) - User Guide User Manual

Page 189

background image

188

CHAPTER 23 CLICK 301

Physical Features

The Click 301 has several communication ports, as well as features for configuration (see

Figure 23.2).

Figure 23.2 – Diagram of the Click 301

Communication Ports

The back of the Click 301 features a 5-position connector that plugs into a T-bus connector

and provides power and RS-485 communication to the device. It also passes RS-485 com-

munication from the module to all other devices on the T-bus.

The top of the device has a pluggable screw terminal block that features -485, one +485

and two ground screw terminals for wiring RS-485 communication. This screw terminal

block can be removed for easy preinstallation wiring. It will not be necessary to wire RS-485

through the screw terminal block if the device is connected to a T-bus with uninterrupted

RS-485 communication.

The front of the Click 301 features a DB-9 connector for RS-232 communication. A straight-

through cable can be used to connect from this port to a computer so that the device can

be configured using Click Supervisor. The front of the device also has an RJ-45 jack for

Ethernet communication.

Any data on one port will be transmitted simultaneously on all other ports.

This manual is related to the following products: