Physical features, Installation – Wavetronix Click 400 (900 MHz radio) (CLK-400) - User Guide User Manual
Page 153
152
CHAPTER 14 • CLICK 201/202/204
Physical Features
Click 201/202/204 modules have the following physical features.
Figure 14.2 – Diagram of the Click 202
Click 201/202/204 modules are wired through the pluggable screw terminal blocks on the
top and bottom of each module. The top block has either two or four screw terminal con-
nections for wiring AC in. DC out is wired through the bottom of the module. The Click
202 and 204 feature one screw terminal block on the bottom of the module, while the Click
201 has two. The screw terminal blocks are red-keyed, allowing them to plug only into their
proper slots.
Click 201/202/204 modules also have a green activity indicator light marked DC OK on the
faceplate. This light glows steadily when the module is working properly, but will go out if
the power supply is interrupted or if the DC connection is shorted.
Finally, the devices also have a potentiometer, marked “22.5–28.5 V DC,” located on the
faceplate beneath the LED. This can be used to set the DC output voltage. Insert a small
screwdriver into the hole and twist clockwise to raise the voltage and counterclockwise to
lower it. Voltages from 22.5–28.5 VDC are allowed. Change this setting only if instructed to
do so by Wavetronix Technical Services.
Installation
The Click 201/202/204 devices are wired through the pluggable screw terminal blocks lo-
cated on the tops and bottoms of the modules. Refer to the tables and figures below to cor-
- Click 421 (bluetooth to serial converter) (CLK-421) - User Guide Click 342 (lean managed ethernet switch) (CLK-342) - User Guide Click 341 (lean managed ethernet switch) (CLK-341) - User Guide Click 340 (lean managed ethernet switch) (CLK-340) - User Guide Click 331 (unmanaged ethernet switch) (CLK-331) - User Guide Click 330 (unmanaged ethernet switch) (CLK-330) - User Guide Click 304 (RS-232 to RS-485 converter) (CLK-304) - User Guide Click 305 (RS-232 to RS-485 converter) (CLK-305) - User Guide Click 301 (serial to ethernet converter) (CLK-301) - User Guide Click 100 (16 output contact closure) (CLK-100) - User Guide Click 104 (4-channel DIN rail contact closure) (CLK-104) - User Guide Click 110 (4-channel contact closure eurocard) (CLK-110) - User Guide Click 112 (detector rack card) (CLK-112) - User Guide Click 114 (detector rack card) (CLK-114) - User Guide Click 120 (screw terminal relay) (CLK-120) - User Guide Click 121 (spring cage relay) (CLK-121) - User Guide Click 200 (surge suppression) (CLK-200) - User Guide Click 201 (1 amp AC to DC converter) (CLK-201) - User Guide Click 202 (2 amp AC to DC converter) (CLK-202) - User Guide Click 203 (UPS and battery) (CLK-203) - User Guide Click 204 (4 amp AC to DC converter) (CLK-204) - User Guide Click 210 (AC circuit breaker) (CLK-210) - User Guide Click 211 (AC outlet) (CLK-211) - User Guide Click 221 (DC surge protector) (CLK-221) - User Guide Click 222 (system surge protector) (CLK-222) - User Guide Click 223 (dual-485 surge protector) (CLK-223) - User Guide Click 230 (AC surge protector) (CLK-230) - User Guide Click 250 (wireless surge protector) (CLK-250) - User Guide