Dip switches – Wavetronix Click 400 (900 MHz radio) (CLK-400) - User Guide User Manual
Page 87
86
CHAPTER 9 • CLICK 110
Location
No
No
Yes
Device ID
No
No
Yes
Fault Status
No
Fault Indicators
Read-only
To use this
configuration feature:
Hardware Configu-
ration Mode
Software Configu-
ration Mode
Software Configu-
ration Mode
Table 9.1 – Click 110 Configuration Options
The final row on the table refers to configuration modes. The DIP switches can be used to
choose between Hardware and Software modes. If the switches are set to Hardware mode,
the DIP switches will be used to change configuration options. If the switches are set to Soft-
ware mode, the front panel menu and Click Supervisor will be used to change configuration
options. This will be discussed in greater detail in the DIP Switches section of this chapter.
Note
Any setting which has been configured via the DIP switches will be read-only in Click
Supervisor and the front panel menu.
DIP Switches
The DIP switches are located on the circuit board behind the faceplate. The side of the face-
plate contains information on configuring using the DIP switches, as shown in Figure 9.6.
- Click 421 (bluetooth to serial converter) (CLK-421) - User Guide Click 342 (lean managed ethernet switch) (CLK-342) - User Guide Click 341 (lean managed ethernet switch) (CLK-341) - User Guide Click 340 (lean managed ethernet switch) (CLK-340) - User Guide Click 331 (unmanaged ethernet switch) (CLK-331) - User Guide Click 330 (unmanaged ethernet switch) (CLK-330) - User Guide Click 304 (RS-232 to RS-485 converter) (CLK-304) - User Guide Click 305 (RS-232 to RS-485 converter) (CLK-305) - User Guide Click 301 (serial to ethernet converter) (CLK-301) - User Guide Click 100 (16 output contact closure) (CLK-100) - User Guide Click 104 (4-channel DIN rail contact closure) (CLK-104) - User Guide Click 110 (4-channel contact closure eurocard) (CLK-110) - User Guide Click 112 (detector rack card) (CLK-112) - User Guide Click 114 (detector rack card) (CLK-114) - User Guide Click 120 (screw terminal relay) (CLK-120) - User Guide Click 121 (spring cage relay) (CLK-121) - User Guide Click 200 (surge suppression) (CLK-200) - User Guide Click 201 (1 amp AC to DC converter) (CLK-201) - User Guide Click 202 (2 amp AC to DC converter) (CLK-202) - User Guide Click 203 (UPS and battery) (CLK-203) - User Guide Click 204 (4 amp AC to DC converter) (CLK-204) - User Guide Click 210 (AC circuit breaker) (CLK-210) - User Guide Click 211 (AC outlet) (CLK-211) - User Guide Click 221 (DC surge protector) (CLK-221) - User Guide Click 222 (system surge protector) (CLK-222) - User Guide Click 223 (dual-485 surge protector) (CLK-223) - User Guide Click 230 (AC surge protector) (CLK-230) - User Guide Click 250 (wireless surge protector) (CLK-250) - User Guide