beautypg.com

Wavetronix Click 400 (900 MHz radio) (CLK-400) - User Guide User Manual

Page 186

background image

CHAPTER 22 • CLICK 250 185

Figure 22.4 – Connecting the Grounding Wire

2 Get a coaxial cable that’s female on one end and male on the other. Connect the female

connector to the antenna connector on the wireless communication module, and con-

nect the male connector to the nonbulkhead (smaller) end of the Click 250.

3 Remove the nut and lock washer from the bulkhead (larger) end of the Click 250, then

insert that end into the hole in the side of the cabinet.

4 Push the provided rubber washer over the bulkhead end, which should now be on the

outside of the cabinet. Reattach the nut and lock washer and tighten.

Figure 22.5 – Mounting the Click 250 in the Cabinet

5 Get a coaxial cable that is female on both ends. Connect one end to the bulkhead end

of the Click 250. Connect the other end to the antenna.

6 Connect the grounding wire from step 1 to the ground lug in the cabinet or another

earth ground location.

Figure 22.6 – Connecting to Earth Ground

This manual is related to the following products: