beautypg.com

Wavetronix Click 400 (900 MHz radio) (CLK-400) - User Guide User Manual

Page 61

background image

60

CHAPTER 7 CLICK 101

Under the Diagnostics tab, you can run diagnostics on your device (see Figure 7.10). Click

the General button to run diagnostics on the items listed below the button. If a problem is

detected, the program will display a red square next to the item in question. If no problems

are detected, a green circle will appear.

Figure 7.10 – Expert Driver Diagnostics Tab

Once you have finished, use the menu bar at the top of the screen to save your settings,

return to the Select Driver screen, and more.

˽

The Save menu allows you to save your settings. Select Save to File to save your set-

tings to a file. Selecting this will open a directory box, allowing you to name your

settings file. This file will always be saved in the Wavetronix folder created when you

installed Click Supervisor, under Wavetronix > ClickHome > Drivers > 101 > User. You

can also select Save to Device to save your settings to your Click 101.

Note

If you do not save your settings to your Click 101, they will be lost the next time you
power the device down.

˽

The Tools menu contains five options for working with your device. Reset > System

power cycles your device, while Reset > Factory Default restores your device to the

settings with which it was shipped. Restore will restore the driver to the settings cur-

rently saved on the Click 101, erasing any unsaved changes. Upgrade can be used to

manually upgrade to the most current firmware for your device. Hex View changes the

view of certain settings in the driver to hexadecimal.

˽

Clicking the Quit menu exits the driver and returns you to the Click Supervisor main

page.

This manual is related to the following products: