Troubleshooting – Wavetronix Click 400 (900 MHz radio) (CLK-400) - User Guide User Manual
Page 144
CHAPTER 12 • CLICK 172/174 143
Note
You do not want to connect to the DB-9 on the Click 200 because this will connect
you to the sensor’s native RS-232 communication link. This link is not normally used
for detection calls.
Troubleshooting
If you repeatedly get an error “Er” while the Settings switch is in the 2 (Lane) position, you
may need to complete the following steps to clear the lane mapping memory buffer:
1 Move the Settings switch to position 1 (Mode).
2 Once the display shows “Pr,” press and release the Channel button.
3 Press and release the Select button to change the operation mode to “Pu” and press the
Channel button again. Follow these steps for each operation mode.
4 Once this has been done for every mode, move the Settings switch to position 2 (Lane).
After completing these steps, you should be able to continue the normal configuration pro-
cess.
- Click 421 (bluetooth to serial converter) (CLK-421) - User Guide Click 342 (lean managed ethernet switch) (CLK-342) - User Guide Click 341 (lean managed ethernet switch) (CLK-341) - User Guide Click 340 (lean managed ethernet switch) (CLK-340) - User Guide Click 331 (unmanaged ethernet switch) (CLK-331) - User Guide Click 330 (unmanaged ethernet switch) (CLK-330) - User Guide Click 304 (RS-232 to RS-485 converter) (CLK-304) - User Guide Click 305 (RS-232 to RS-485 converter) (CLK-305) - User Guide Click 301 (serial to ethernet converter) (CLK-301) - User Guide Click 100 (16 output contact closure) (CLK-100) - User Guide Click 104 (4-channel DIN rail contact closure) (CLK-104) - User Guide Click 110 (4-channel contact closure eurocard) (CLK-110) - User Guide Click 112 (detector rack card) (CLK-112) - User Guide Click 114 (detector rack card) (CLK-114) - User Guide Click 120 (screw terminal relay) (CLK-120) - User Guide Click 121 (spring cage relay) (CLK-121) - User Guide Click 200 (surge suppression) (CLK-200) - User Guide Click 201 (1 amp AC to DC converter) (CLK-201) - User Guide Click 202 (2 amp AC to DC converter) (CLK-202) - User Guide Click 203 (UPS and battery) (CLK-203) - User Guide Click 204 (4 amp AC to DC converter) (CLK-204) - User Guide Click 210 (AC circuit breaker) (CLK-210) - User Guide Click 211 (AC outlet) (CLK-211) - User Guide Click 221 (DC surge protector) (CLK-221) - User Guide Click 222 (system surge protector) (CLK-222) - User Guide Click 223 (dual-485 surge protector) (CLK-223) - User Guide Click 230 (AC surge protector) (CLK-230) - User Guide Click 250 (wireless surge protector) (CLK-250) - User Guide