Gasboy TopKAT Operation Manual - Manual (Page 83)

MDE-4338A TopKAT™ Fuel Management System Operation Manual · February 2009 Page 75
Accessing the Utilities Menu Diagnostics and Utilities
Keypad: PCMCIA TEST
Use this command to run a test on the PCMCIA card where the system writes and reads back
data to and from the card without destroying the contents of the card.
1 Insert the PCMCIA card into the socket on the PCMCIA board until it snaps into place.
2 At PCMCIA TEST, press ENTER.
The system performs checks on the card and displays a series of messages (that is, powering
up card, testing card, please wait). Then one of the following messages appears:
• PCMCIA CARD PASSED or PCMCIA CARD FAILED
• CARD NOT INSERTED
Action: Insert card.
• BATTERY DEAD
Action: Replace battery in PCMCIA card.
• BATTERY LOW PRESS ESC [ENTER TO CONT]
Action: Battery on PCMCIA card is low. Backup/restore may be able to take place, but is
risky. Press ESC to exit and replace battery. Press ENTER to continue the test.
• WRITE PROTECTED
Action: Card is write-protected and test cannot proceed. Alter the write-protect status of
the card and retry the test.
Accessing the Utilities Menu
When accessing diagnostics and utilities functions, pumps must be stopped. If no transactions
are in progress, pumps are automatically stopped. If there are transactions in progress, you are
prompted to stop them. If pumps are in run status when entering diagnostic mode, they are
returned to run status when diagnostic mode is exited.
To access the Utilities Menu, proceed as follows:
1 Access the Main Menu.
2 When COMMAND: UTILITIES appears, press ENTER.
3 At the PCMCIA BAK/RESTORE command, press ENTER.