With the procedure, Configure satellite pcus for mechanical i/f pumps – Gasboy TopKAT Operation Manual User Manual
Page 62
Tank, Pump, and PCU File Setup - Keypad
About the PCU File
Page 54 MDE-4338A TopKAT™ Fuel Management System Operation Manual · February 2009
Configure Master Unit for Electronic Pump
To configure Master Unit for Electronic Pump, proceed as follows:
1
At PCU SETUP: LOAD # SATELLITES, press ENTER.
2
Type the number of satellite units (1 - 7) and press ENTER. Use the down arrow to proceed.
3
At EDIT PCUS, press ENTER.
4
At EDIT PCUS: MASTER, press ENTER. Define the characteristics of your master unit.
• At LOAD # of PUMPS, press ENTER. Type the number of pumps attached to the master
(1 - 8) and press ENTER. Use the down arrow key to proceed.
• At LOAD BASE PUMP, press ENTER. Indicate the base pump number (01 - 99) and
press ENTER. Use the down arrow to proceed.
• At PCU ASSIGNMENTS, press ENTER. The system displays the current slots assigned
to each pump starting with the lowest pump number. Use the down arrow to display other
pumps.
• At PUMP #nn SLOT, press ENTER. The prompt PCU SLOT appears. Type the required
slot number and press ENTER.
• Press PREV until EDIT PCUS: MASTER displays.
5
Press the down arrow until EDIT PCUS: SATELLITES displays. Press ENTER. Continue
with the procedure
“Configure Satellite PCUs for Mechanical I/F Pumps”
on
.
Configure Satellite PCUs for Mechanical I/F Pumps
At EDIT SATELLITE PCU: SATELLITE #1, press ENTER to display the characteristics for
the first satellite. If another satellite is required, press the arrow keys until the required number
displays. Then press ENTER.
• At LOAD # of PUMPS, press ENTER. Type the number of pumps attached to the satellite
(1 or 2) and press ENTER. Use the down arrow key to proceed.
• At LOAD BASE PUMP, press ENTER. Indicate the base pump number (01 - 99) and
press ENTER. Use the down arrow to proceed.
• At MECH PUMP SETUP, press ENTER. The system displays the current pump numbers.
Press ENTER at the required pump number. Use the down arrow to proceed.
• At PULSE RATE, press ENTER. Use the down arrow until the required pulse rate
displays and press ENTER. Use the down arrow to proceed.
• At PUMP SWITCH TIMER, press ENTER. Type a value from .1 to 1.0 and press
ENTER (refer to
for details on this parameter).
• Press PREV until EDIT SATELLITE PCU: SATELLITE #x displays. If configured for
more than one satellite, repeat the satellite procedure to set up the remaining satellite units.