Gasboy TopKAT Operation Manual - Manual (Page 106)

Terminal Commands Accessing the Terminal Commands
Page 98 MDE-4338A TopKAT™ Fuel Management System Operation Manual · February 2009
COnfigure Units (CO U)
Use this command to identify the units of measure to be used with your system. The system
first displays a menu of categories, then displays a menu of choices within that category.
Select the appropriate units for your application.
1 Type CO U. The system appears.
MEASUREMENT UNITS
1. DISTANCE
2. QUANTITY
3. DATE FORMAT
4. RATE
5. PUMP TIMEOUT MODE
6. ALL
ENTER (1-6):
2 Select the required units category or select 6 (All) to display the units selection prompts one
after the other.
3 When the category menu displays, select the required units. Refer to “MEASUREMENT
UNITS (only for Master and Standalone Modes)” on page 33 for a list of available choices.
After a selection is complete, the menu reappears. Press ENTER to exit.
DElete RECord (DE REC)
Use this command to delete a record from either the vehicle file or the manual entry file.
Deletion criteria for the vehicle file is by key number or vehicle and department number
combination; for the manual entry file, deletion criteria is by the manual entry field value.
1 Type DE REC.
The system prompts Select File - (V)ehicle or (E)mployee:.
Note: The file name of the second file will differ depending on which name is used for your
manual entry file. These examples use the manual entry filename EMPLOYEE.
2 Type V or E.
The appropriate prompt appears depending on what you select.
• For the vehicle file (V), the prompts are Select (K)ey or (V)eh/dept (or (V)eh/Acct). Type
K or V. At the next prompt, type the number.
• For the manual entry file (E), the prompt is the manual entry field name. Type the number.
The system prompts Are you sure? (Y)es or (N)o.
3 Type the appropriate response.