Gasboy TopKAT Operation Manual - Manual (Page 31)

MDE-4338A TopKAT™ Fuel Management System Operation Manual · February 2009 Page 23
Typical Fueling Sequence - Standalone or Master/Satellite System Overview
5 If you are required to enter an odometer reading, the LCD displays: ENTER ODOMETER.
Use the keypad to enter the mileage that appears on your vehicle’s odometer (up to six digits,
no tenths). The digits appear as they are entered. If you make a mistake, press CLEAR and
enter the reading again. When you enter the correct reading, press ENTER. The system
performs a reasonability check and if the reading is accepted, it writes the value to the key
(into the last odometer field). If the entered odometer is not accepted, you can retry entry up to
the number of times specified in the LOAD ODOMETER RETRIES command.
6 If your system requires a manual entry, the LCD displays the prompt for that field. Enter the
data requested using the keypad. The digits appear as they are entered. If you make a mistake,
press CLEAR and reenter the data. When you enter the correct data, press ENTER.
7 If you are required to enter a PIN, the LCD displays: ENTER PIN.
Using the keypad, enter your PIN number and press ENTER. To ensure security, an asterisk
(*) appears for each digit that you press. If you make a mistake while entering your PIN, press
CLEAR and enter it again.
You have three tries to enter the correct PIN. If you have a key system, after the third
unsuccessful try, the display instructs you to TURN KEY LEFT, REMOVE. Turn and remove
your key, then start again at step
3 . If you have a non-key system, after the third unsuccessful
try, the display returns to the configured idle message (step 2 ) and you must restart at step 3 .
If your system uses the Auto Pin Lockout feature, the key is automatically locked out
(invalidated) after the third unsuccessful PIN entry.
8 The LCD displays SELECT PUMP. Enter the required pump number and press ENTER. If
you have only one pump, the system automatically selects it and does not prompt.
If the pump you selected cannot be accessed, one of the following messages appears:
• INVALID PUMP
• PUMP IN USE
• PUMP DISABLED
• INVALID FUEL
You have three tries to select a correct pump. If after three attempts, you have not chosen a
correct pump, the display for a key system instructs you to TURN KEY LEFT, REMOVE.
Turn and remove your key, then start again at step
3 . For a non-key system, the display returns
to the configured idle message (step 2 ) and you must restart at step 3 .
If the pump is available and you are authorized to use it, the display will show:
PUMP #xx IS READY
TURN KEY LEFT, REMOVE.
Note: Non-key systems will display the top line message only. Skip to step 10 .
9 Remove the key from the receptacle. If you leave the key in the receptacle for more than five
seconds, an alarm sounds to remind you to remove it.