Record error trans, Config trans logger, Memory full protection – Gasboy TopKAT Operation Manual User Manual
Page 65
MDE-4338A TopKAT™ Fuel Management System Operation Manual · February 2009
Page 57
Config Trans File
Transaction File Setup - Keypad
Record Error Trans
Set Record Error Trans to a YES or NO value.
• YES means that error transactions will be saved in memory.
• NO means that error transactions will not be saved in memory.
Note: Retaining error transactions may be useful in diagnosing system/key problems;
however, if transaction space is at a premium, you may elect not to save error
transactions.
Config Trans Logger
Set Config Trans Logger to an ENABLED or DISABLED value depending on whether you
want to use direct printout mode or not.
Note: If you have a logger (printer) connected to record transactions, be sure to set this value
to ENABLED.
Memory Full Protection
The Memory Full Protection feature is set to YES or NO.
• When set to YES, and transaction memory becomes full, the system will not accept further
transactions and will display a MEMORY FULL message.
• When set to NO, and transaction memory becomes full, the system will start overwriting
transactions, as new transactions occur. This can result in loss of transactions. Refer to
for ways to ease memory-full conditions.