Gasboy TopKAT Operation Manual - Manual (Page 41)

MDE-4338A TopKAT™ Fuel Management System Operation Manual · February 2009 Page 33
Setup Menu Getting Started/System Setup
MEASUREMENT UNITS (only for Master and Standalone Modes)
This command allows you to indicate, for reporting and transactions, the type/format of units
of measure.
• DISTANCE provides 3 options: MILES, KILOMETERS, HOURS.
• QUANTITY provides 3 options: GALLONS, LITERS, LITRES.
• DATE FORMAT provides 3 options: MM/DD/YY, YY/MM/DD, DD/MM/YY.
• RATE allows you to indicate how you want your fuel efficiency monitored: MPG=miles
per gallon; HPG=hours per gallon; L/100KM=liters per 100 kilometers; LPH=liters per
hour; KM/L=kilometers per liter; HPL=hours per liter.
Note: When you select hours, instead of miles, kilometers, or liters, no system prompts are
changed. The system will still request ENTER ODOMETER. However, in reports (Print
System or Department/Vehicle) or print transactions, units will appear as hours.
• PUMP TIMEOUT MODE allows one of two time-out modes to be selected: USA or
INTERNATIONAL. USA allows for a maximum of 180 seconds, as required by Weights
and Measures. INTERNATIONAL allows for a maximum of 255 seconds.
BULK FUELING (only for Master and Standalone Modes)
This command allows you to indicate whether bulk fueling operations will be active at this
site. Select YES or NO accordingly.
Note: The PCU Type must be set to four-hose mechanical or two-hose mechanical to use bulk
fueling. If bulk fueling is set to Yes, All 9800 and 9800 + Mech cannot be selected as
PCU types.