Gasboy TopKAT Operation Manual - Manual (Page 68)

Modem Initialization - Keypad PRINT MODEM INIT
Page 60 MDE-4338A TopKAT™ Fuel Management System Operation Manual · February 2009
PRINT MODEM INIT
When you select PRINT MODEM INIT, you are prompted to view string 1 or string 2. This
choice can also be done as the terminal command PRINT MODEM.
1 At the COMMAND: SETUP prompt, press the arrow key until MODEM appears. Press
ENTER.
2 At PRINT MODEM INIT, press ENTER. The system prompts: STRING 1.
• To display string 1, press ENTER.
• To display string 2, press the down arrow and press ENTER.
3 To return to the SETUP prompt, press PREV until the SETUP prompt appears.
INIT MODEM
When you select INIT MODEM, the modem strings that were input using the LOAD
MODEM terminal command are sent to the modem and a result response displays on line two
of the display.
1 At the COMMAND: SETUP prompt, press the arrow key until MODEM appears. Press
ENTER.
2 Press the arrow keys until INIT MODEM appears. Press ENTER.
The system displays …please wait and then one of the following result codes:
Result Description
SUCCESSFUL No command errors and Q1 is present in string 2
STRING 1 FAILED Incorrect modem command was detected
STRING 2 FAILED Incorrect modem command was detected
NO RESPONSE Modem not present or not functioning; or Q1 is in string 1
STRINGS OK, NO Q1 Modem commands are correct but Q1 is not present in string 2
There are three commands that should not be sent to the modem because the results will be
unpredictable:
ATR go off hook
E1 enable command echo (This is the default, however E0 is sent in the default initialization string to the
TopKAT. Do not change the TopKAT string to E1)
&V display current configuration