Gasboy TopKAT Operation Manual - Manual (Page 102)

Terminal Commands Accessing the Terminal Commands
Page 94 MDE-4338A TopKAT™ Fuel Management System Operation Manual · February 2009
COnfigure PIn (CO PI)
Use this command to indicate whether the system should lock out keys when 3 consecutive
invalid PIN entries are made.
1 Type CO PI.
The system responds INVALID PIN LOCKOUT (Y)ES OR (N)O.
2 Type Y to lock out keys when 3 consecutive invalid PIN entries are made.
~ OR ~
Type N to ignore invalid PIN entries and allow retries.
COnfigure SYstem (CO SY) - Standalone Electronic or Mechanical PCU
Use this command to configure the operating characteristics of your standalone system. If you
have the master/satellite option, your prompts will differ. Refer to the command sequence
following this one.
1 Type CO SY.
The system displays a menu containing the system parameters.
CONFIGURE SYSTEM
1. SITE NO.
2. SYSTEM ID
3. NO. OF PUMPS
4. BASE PUMP NO.
5. PUMP TIMEOUTS
6. NO. OF TANKS
7. POLL ADDRESS
8. NO. OF PCUS
9. ALL
ENTER (1-9):
The next system prompt varies depending on the option you select.
• If you select option 9 (All), system parameters display one after the other until all are
completed.
• Refer to the following table for guidance on what to enter for the other prompts.
Descriptions of these parameters appear in “Setup Menu” on page 30 .
Selection Prompt Enter
1 LOAD SITE NO: (xxxx) 4-digit site number
2 LOAD SYSTEM ID (xxxx) 4-digit system ID, assigned at the factory
3 LOAD NO. OF PUMPS (x) number of pumps supported by TopKAT
4 LOAD BASE PUMP NO: (xx) base pump number (1-99)
5 LOAD PUMP TIMEOUTS (xxx) time-out value
6 LOAD NO. OF TANKS (x) number of tanks supported by TopKAT
7 LOAD POLL ADDRESS (xx) poll address for computer communication (usually 01)
8 LOAD NO. OF PCUS (xx) number of PCUs supported by TopKAT
2 After a selection is complete, the menu reappears. Press ENTER to exit.