Gasboy TopKAT Operation Manual - Manual (Page 112)

Terminal Commands Accessing the Terminal Commands
Page 104 MDE-4338A TopKAT™ Fuel Management System Operation Manual · February 2009
Load RETry (L RET)
Use this command to load up to two digits for the number of times the odometer will be re-
prompted for when an incorrect odometer has been entered.
1 Type L RET.
The system responds LOAD ODOM RETRIES (xx):
2 Enter the required number.
Load TAnk (L TA)
Use this command to indicate the inventory type and amount in each tank.
1 Type L TA.
The system displays LOAD TANK TABLE ENTER TANK #.
2 Type the appropriate tank number.
The system responds ENTER PRODUCT CODE (x):.
3 Enter the appropriate one-digit product code.
The system responds ENTER AMOUNT (xxxxxxx.xxx).
4 Enter the amount of product in the tank.
The system responds ENTER TANK #:.
5 Repeat this process from Step 2 until all tanks are defined.
Load TIMe (L TIM)
Use this command to load the current system time.
1 Type L TIM.
The system responds LOAD TIME (HHMM): (xxxx)
2 Type the appropriate time in the format shown in the system response.
Load TRansactions (L TR)
Use this command to load the starting transaction number. When you first start up your
system, this number is usually set to 0001 so the first transaction will be 0001; however it can
be set to any number you wish.
1 Type L TR.
The system responds LOAD TRANS NUMBER: (xxxx)
2 Type a four-digit number for the first transaction.