Gasboy TopKAT Operation Manual - Manual (Page 67)

MDE-4338A TopKAT™ Fuel Management System Operation Manual · February 2009 Page 59
About Modem Initialization Modem Initialization - Keypad
9 – Modem Initialization - Keypad
About Modem Initialization
The Modem feature allows you to input one or two strings of modem commands up to 39
characters each (the 39-character limitation is a modem requirement). When the system is
reset these default modem stings are loaded:
String 1 AT&D2V1E0S0=1&C1B1
String 2 AT&WQ1
There are two ways to access the modem feature, from a terminal command or from the
keypad setup menu.
• Modem strings are entered using the LOAD MODEM (LO MOD) terminal command and
they can be printed using the PRINT MODEM (PR MOD) command or initialized using
the INITIALIZE MODEM (I MOD) command (refer to
“Terminal Commands” on
page 87 ).
• Keypad menu options allow you to print the modem strings and issue the initialize modem
command to send the strings to the modem.
Keypad menu options are located on the SETUP Menu. MODEM appears after CONFIG
TRANS FILE and before STOP. When you select MODEM, there are two menu choices:
• PRINT MODEM INIT
• INIT MODEM
Note: If the modem is not enabled, these selections come up as not available.