Gasboy TopKAT Operation Manual - Manual (Page 25)

MDE-4338A TopKAT™ Fuel Management System Operation Manual · February 2009 Page 17
Report Printer Interface Option - Standalone or Master Only System Overview
Loading Paper
When printer paper is getting low, a pink band will appear on the edge of the paper.
Replacement paper is available from Gasboy, P/N C01819. Follow these steps to replace the
paper and see
Figure 3-3 .
Figure 3-3: Printer - Side View
1 To access the printer, insert the key into the key slot located at the right-hand side of the bezel.
Turn it clockwise, then pull outward to open the bezel.
2 Looking at the rear side of the bezel, locate the printer paper holder and printhead mechanism.
At the right-hand side of the printhead, locate the printhead paper feed wheel.
3 Turn the paper feed wheel counterclockwise until the paper is removed.
Note: If the paper does not move when the paper feed wheel is rotated, the paper pressure
lever is in the pressure release position. Rotate the lever toward you so that it points
straight downward. This places the lever in the pressure engage position.
4 Using a flat-blade screwdriver, remove the screw and the small metal plate securing the left
side of the paper holder. Remove the old paper roll.
5 Take the new paper roll and feed the paper into the paper slot. Turn the paper feed wheel
clockwise until paper catches.
6 Install the paper roll on the spindle with the paper feeding counterclockwise, over the top of
the roll and into the slot.