Gasboy TopKAT Operation Manual - Manual (Page 108)

Terminal Commands Accessing the Terminal Commands
Page 100 MDE-4338A TopKAT™ Fuel Management System Operation Manual · February 2009
3 The prompts for the selected file type are displayed along with their current values. Press
ENTER to accept the value and move to the next prompt. Change any values you wish.
When changing record values, after you change the required value, you may exit from the
record without going through all of the fields.
• At the first position in a field, press the CTRL and L keys, then press ENTER. This saves
your new entries and returns you to the beginning record prompt.
• To exit from a record and return to the command mode prompt, press the CTRL and C
keys, then press ENTER.
ENable PRotection (EN PR)
Use this command to enable memory-full protection. The Memory-Full Protection feature is
set to YES or NO.
• When set to YES, and transaction memory becomes full, the system will not accept further
transactions and will display a MEMORY FULL message.
• When set to NO, and transaction memory becomes full, the system will start overwriting
transactions, as new transactions occur.
Refer to “Move POinter (M PO)” on page 105 for ways to ease memory-full conditions.
ENable PUmp (EN PU)
Use this command to enable a pump after a disable command. If pump is already enabled,
system displays PUMP ALREADY ENABLED.
1 Type EN PU.
The system prompts ENTER PUMP #:
2 Type the required pump number.
The system responds PUMP ENABLED.
EXit (EX)
Use this command to exit from command mode at the terminal.
Type EX.
The system exits command mode. If connected to Port 2 and the logger is enabled, direct
printout mode is entered.
Help (H)
Use this command to display a listing of all terminal commands and their short forms (letters
in uppercase).
Type H.
Refer to “Appendix A: HELP Command” for more information on this command.