Gasboy TopKAT Operation Manual - Manual (Page 104)

Terminal Commands Accessing the Terminal Commands
Page 96 MDE-4338A TopKAT™ Fuel Management System Operation Manual · February 2009
COnfigure SYstem (CO SY) - Master/Satellite Mechanical; Master/Satellite
Combination
Use this command to configure the operating characteristics of your master/satellite system.
1 Type CO SY.
The system displays a menu containing the system parameters.
CONFIGURE SYSTEM
1. SITE NO.
2. SYSTEM ID
3. NO. OF SATELLITES
4. PUMP TIMEOUTS
5. NO. OF TANKS
6. POLL ADDRESS
7. ALL
ENTER (1-7):
The next system prompt varies depending on the option you select.
• If you select option 7 (All), system parameters display one after the other until all are
completed.
• Refer to the following table for guidance on what to enter for the other prompts.
Descriptions of these parameters appear in “Setup Menu” on page 30 .
Selection Prompt Enter
1 LOAD SITE NO: (xxxx) 4-digit site number
2 LOAD SYSTEM ID (xxxx) 4-digit system ID, assigned at the factory
3 LOAD NO. OF SATELLITES (x) number of satellites supported by TopKAT
4 LOAD PUMP TIMEOUTS (xxx) time-out value
5 LOAD NO. OF TANKS (x) number of tanks supported by TopKAT
6 LOAD POLL ADDRESS (xx) poll address for computer communication (usually 01)
2 After a selection is complete, the menu reappears. Press ENTER to exit.