Comtech EF Data CDM-IP 300L - Manual (Page 40)

CDM-IP 300L IP-Centric Satellite Modem Rev. 1
CD/CDMIP300L.IOM
12
1.4 O
PTIONS
Enhancing the CDM-IP’s performance is easy. Additional features can be added quickly
on site, using the FAST access code purchased from Comtech EF Data. To enable these
features, simply enter the code at the front panel.
Option Description Install Option
Single Data/Code Rate User defined data rate FAST
Low Rate Variable 2.4 to < 512 kbps FAST (Standard)
Full Rate Variable 2.4 to < 5.0 Mbps (QPSK Maximum is 4.375 ) FAST
OQPSK FAST
8-PSK Requires Viterbi, Reed-Solomon Codec User
TX/RX L-Band ± 0.02 ppm L-Band modem with high stability reference Factory (Standard)
TX Only, L-Band ± 0.02 ppm Hardware limited with high stability reference Factory
RX Only, L-Band ± 1.0 ppm Hardware limited with 1 ppm reference Factory
TX/RX L-Band ± 1.0 ppm L-Band modem with 1 ppm reference Factory
Sequential or Viterbi Codec Modem can be supplied with either Viterbi or
Sequential FAST
TX Reed-Solomon Codec Concatenates with Viterbi User
RX Reed-Solomon Codec Concatenates with Viterbi User
Turbo Codec Full Rate Turbo Codec. Requires Reed-
Solomon Codec removal. User
AUPC Requires Reed-Solomon cards User or FAST
3xDES Data Encryption Uses NIST certified 3x core
Software Version 1.1.0 and later FAST
IP Header Compression Software Version 1.1.0 and later FAST
Payload Compression Software Version 1.3.0 and later FAST
Quality of Service (QoS) TX required; Software Version 1.1.0 and later FAST
Primary Power: 48 Vdc Modem only, No BUC Factory
Primary Power: Auto-ranging
AC 90 to 264 Vac Factory
ODU DC Power: 24V or 48V.
Primary Input = AC only 100W @24V
150W @ 48V Factory
Note: Enabling the CDM-IP Demo Mode from the front panel can temporarily enable all
IP FAST Options (except 3xDES Encryption) for evaluation. Once enabled, the IP FAST
Options will be available for a total time period of seven (7) days (168 hours). The 7-day
Demo Mode is a cumulative counter (can be stopped and started at any time).