Comtech EF Data CDM-IP 300L - Manual (Page 258)

CDM-IP 300L IP-Centric Satellite Modem Rev. 1
CD/CDMIP300L.IOM
232
The following tables are the Alarms and Faults v1 traps / v2 notifications that the CDM-
IP 300L supports.
CDM-IP 300L Alarms and Faults SNMPv1 traps:
cdmip300LModemUnitFaultsTrap 624751
cdmip300LModemTxTrafficFaultsTrap 624752
cdmip300LModemRxTrafficFaultsTrap 624753
CDM-IP 300L Alarms and Faults SNMPv2 notifications:
cdmip300LModemUnitFaultsTrap 1.3.6.1.4.1.6247.5.1.9.0.624751
cdmip300LModemTxTrafficFaultsTrap 1.3.6.1.4.1.6247.5.1.9.0.624752
cdmip300LModemRxTrafficFaultsTrap 1.3.6.1.4.1.6247.5.1.9.0.624753
8.5.1.9 C
DM
-
IP
SNMP T
RAP
C
ONFIGURATION
Table 40. CDM-IP SNMP Trap Configuration OIDs
OID Description
cdmipSnmpTrapDestinationIpAddress Specifies where the trap should be sent. This is
usually the IP address of a network
management application (such as HP Openview
or Castlerock SNMPc). It could also be the IP
address of a trap ringer console (such as MG-
SOFT MIB Browser).
cdmipSnmpTrapCommunity Community name that is sent with the trap. This
community name is checked by the network
management application or MIB browser to
determine if it should accept or discard the trap
being sent to it.
cdmipSnmpTrapVersion Tells the agent if it should send out version 1 or
version 2 traps. The trap format differs
depending on which version is used but contains
the same type of information. The choice of
which trap version to use should depend on
which SNMP version the managing application
is expecting. The OID can be sent to the
following values:
1 SNMPv1
2 SNMPv2