Comtech EF Data CDM-IP 300L - Manual (Page 262)

CDM-IP 300L IP-Centric Satellite Modem Rev. 1
CD/CDMIP300L.IOM
236
OID Description
cdmipIpRouteRowStatus
Used in GET operations to tell if the route
table entry is active. Used in SET operations
to tell if a new route table entry is to be created
or an existing route table entry is to be
deleted.
It returns 1 (active) to indicate that the route
entry is available for use by the managed
device. The values of 2 (notInService) and 3
(notReady) are not supported.
When a new route entry is created, this OID
must be set to 4 (createAndGo). The value of
5 (createAndWait) is not supported.
If an existing row is to be deleted this OID
must be set to 6 (destroy), which indicates that
the user wishes to delete the route from the
route table.
The “cdmipIpRouteRowStatus” can return:
1 Active
The “cdmipIpRouteRowStatus” can be set to
the following for row create/delete:
4 Create And Go
6 Destroy
8.5.2.4 P
ROTOCOLS
G
ROUP
8.5.2.4.1 IGMP Configuration Subgroup
Note: This subgroup will only be accessible in the MIB tree if the IGMP FAST feature has been
purchased and activated. Otherwise, both GETs and SETs on these OIDs will return
errors.
Table 44. IGMP Configuration Subgroup OIDs
OID Description
cdmipIgmpTable Reports the host groups being routed by the
modem. This table shows the minimum time
before a host group will be put out of service.
cdmipIgmpEnable Allows a user to enable or disable the IGMP
feature. When enabled, multicast packets
received from the Satellite Interface are
forwarded to the Ethernet Interface if a host on
the Ethernet LAN has joined the host group via
an IGMP report.
cdmipIgmpQueryPeriod Defines the time interval (in seconds) in which
the modem sends out its host membership
Query messages.