Comtech EF Data CDM-IP 300L - Manual (Page 139)

CDM-IP 300L IP-Centric Satellite Modem Rev. 1
CD/CDMIP300L.IOM
113
Parameter Type Protocol Description
Current
Sweep Value Command:
Response:
>add/CSV_xsnnnnn'cr''lf]
Where:
x = < or > (data modifier to indicate that the sweep offset value is
less than or greater than the returned value).
s = + or - (sweep offset from center).
nnnnn = 0 to 35000.
yyy = OK or FLT (decoder lock status OK or FAULT).
Notes: 1. The 'x' (< or >) parameter is only returned if the level
has exceeded the computational resolution of the
system.
2. 'No Data' is returned if the level cannot be calculated.
3. 'Sampling' is returned if not enough data is currently
available to calculate the level.
5.6 S
TORED
F
AULTS
Information on stored faults is returned when requested. If no stored fault exists for a given fault
number, the words “NO Fault” will be returned instead of the normal time/date status
information.
The following symbols are commonly used to define the stored faults status commands:
# Fault number (0 to 9). “0” is the first fault stored.
hh Hours in 24-hr. format.
mm Minutes.
ss Seconds.
MM Month.
DD Day.
YYYY Year.
Parameter Type Protocol Description
Modulator
Stored Faults Command:
Response:
>add/MSF_# hh:mm:ss
MM/DD/YYYYY'cr'
MOD_xxx'cr'
SYN_xxx'cr'
DCS_xxx'cr'
ICH_xxx'cr'
QCH_xxx'cr'
AGC_xxx'cr'
SCT_xxx'cr'
EXT_xxx'cr'
CONF_xxx'cr''lf']
Module (OK/FLT)
IF Synthesizer (OK/FLT)
Data Clock Synthesizer (OK/FLT)
I Channel (OK/FLT)
Q Channel (OK/FLT)
AGC Level (OK/FLT)
Modem Reference PLL Lock (OK/FLT)
Modem Reference Activity (OK/FLT)
Configuration (OK/FLT)