Rockwell Automation 7000L PowerFlex 7000 Medium Voltage AC Drive C Frame - Marine - Manual (Page 162)

3-66 Operator Interface
7000L-UM302B-EN-P – June 2013 7000 “C” Frame - Marine
Upload to Operator Interface
The parameters are read from the drive and stored in the operator
interface by pressing the [F5] key. The screen will appear as in
Figure 3.93, indicating the operation you are about to perform. The
screen will then ask you to confirm the operation. Press the [F8] key
to proceed, or the [F9] key to abort. Performing a “DRIVE TO
MEMORY” transfer will overwrite any previous parameters stored
within the operator interface.
Figure 3.93 – Transfer Stored Parameters
Download from Operator Interface
The parameters stored in the operator interface are downloaded to
the drive by pressing the [F3] key. A screen similar to that shown in
Figure 3.93 will be shown (except the operation will show
“MEMORY TO DRIVE”). To confirm the operation, press the [F8]
key to proceed, or the [F9] key to abort. Performing a “MEMORY
TO DRIVE” transfer will overwrite the active parameters in the drive.
It will not affect the parameters stored within the drive‟s NVRAM.
After parameters have been downloaded you will be prompted to
make the new parameters downloaded to the drive permanent. Refer
to section “Message Prompting” for further details.
Upload to Memory Card
The parameters are read from the drive and stored on a memory card
by pressing the [F4] key. The operator interface will enter the
DIRECTORY screen in which a parameter filename can be entered.
Refer to the section entitled “Enter a filename”. When the filename
has been obtained, the TRANSFER: PARAMETERS screen such as
that in Figure 3.94 will be displayed, showing the filename,
indicating the operation you are about to perform and showing the
current status of the operation.