Rockwell Automation 7000L PowerFlex 7000 Medium Voltage AC Drive C Frame - Marine - Manual (Page 142)

3-46 Operator Interface
7000L-UM302B-EN-P – June 2013 7000 “C” Frame - Marine
Message Prompting
All the changes you made while you were configuring the drive are
stored in volatile memory of the drive. This means that when power
to the drive is lost, so will be the changes. To permanently store the
changes, the contents of the memory must be stored to NVRAM
memory.
When you exit a group of screens on which you have changed the
drive data, you will be prompted as in Figure 3.62 to save the data.
If you wish to save the data, press [F8] 'Yes' and the NVRAM screen
(refer to Store/Retrieve Configuration) will be entered (Figure
3.63). If you wish the data to reside as temporary data in RAM only,
press [F9] 'No'. Pressing [F10] Exit will return you to the screen
from which you previously exited.
Note that the data can still be saved at a later time by accessing the
NVRAM screen directly from the Top Level Menu. Refer to
Store/Retrieve Configuration.
Figure 3.62 – Message Prompt Screen
Figure 3.63 – NVRAM Screen