Rockwell Automation 1756-XXXX ControlLogix Analog I/O Modules - Manual (Page 275)

Publication 1756-UM009C-EN-P - December 2010 275
Troubleshoot Your Module Chapter 12
Use RSLogix 5000 Software
for Troubleshooting In addition to the status indicator display on the module, RSLogix 5000
software will alert you to fault conditions. Fault conditions are reported in
several ways.
• Warning signal on the main screen next to the module - This occurs
when the connection to the module is broken.
• Message in a screen’s status line.
• Notification in the Tag Editor - General module faults are also reported
in the Tag Editor. Diagnostic faults are reported only in the Tag Editor.
• Status on the Module Info tab.
The following windows display fault notification in RSLogix 5000 software.
Warning Signal on Main Screen
A warning icon appears in the I/O Configuration tree when a communication
fault occurs.
Fault Message in Status Line
On the Module Info tab, in the Status section, the Major and Minor Faults are
listed along with the Internal State of the module.