Rockwell Automation 1756-XXXX ControlLogix Analog I/O Modules - Manual (Page 244)

244 Publication 1756-UM009C-EN-P - December 2010
Chapter 11 Calibrate the ControlLogix Analog I/O Modules
8. Click Next.
The Low Reference Voltage Signals wizard appears to show which
channels will be calibrated for a low reference and the range of the
calibration. It also shows what reference signal is expected at the input.
9. Click Next.
10. Set the calibrator for the low reference and apply it to the module.
TIP
You can select whether to calibrate channels in groups all
at once or each channel at a time. The example above
shows all channels will be calibrated at the same time.
We recommend you calibrate all channels on your module
each time you calibrate. This will help you maintain
consistent calibration readings and improve module
accuracy.
TIP
Click Back to return to the last window to make any
necessary changes. Click Stop to halt the calibration
process, if necessary.