Rockwell Automation 1756-XXXX ControlLogix Analog I/O Modules User Manual

Page 254

background image

254

Publication 1756-UM009C-EN-P - December 2010

Chapter 11 Calibrate the ControlLogix Analog I/O Modules

5.

Click the Calibration Tab on the Module Properties dialog box.

6.

Click Start Calibration to access the Calibration Wizard to step through
the process.

If your module is not in Program mode, a warning message appears.
You must manually change the module to Program mode before
clicking Yes.

IMPORTANT

The ‘Error’ for channel 5 shows that during the previous
calibration the process was not successful for this
particular channel. We suggest a valid calibration be
performed for all channels.

See

for a successful calibration status.