INFICON STC-2002 Thin Film Deposition Controller Operating Manual - Manual (Page 64)

p STC-2002 DEPOSITION CONTROLLER y
SECTION 3.XX e page 62 of 276 ^
Figure- 3.7: Executive Menu.
fixed STATUS Key
Fixed STATUS key removes Main Menu (or any other menu screen) and returns the RunTime Screen. A
second and third press of the STATUS key after the Runtime screen appears will invoke detailed power and
crystal information by channel.
Service Menu
SERVICE menu – This choice brings up the Service MENU which provides selection of : SEQ vs. non-
SEQ product function, return to factory settings, purge ALL stored data, and test mode entry.
Keys toggle functions and key labels alternate between TEST on / TEST off, SEQ / non-SEQ,
etc. To initiate any of the Service MENU personalities, any or all four of the choices are toggled
on or off as needed and the Accept/Restart Product key is pressed. The product will restart with
the selected personalities in effect. Only the user selected SEQ/non-SEQ personality will remain in
effect upon subsequent product power cycles. AS IS, PURGED and FACTORY is a three way
select. Optional Memory Card key allows saving or restoring all parameters, films, processes, and
I/O programs in memory locations A and B to the memory card. ARM RESET allows restarting
with same features selected. The service menu was not included for the casual user. If you are
uncertain about these functions and their effects, do not proceed. See sections: x.x (factory
settings), x.x (test mode) and x.x (password purge).