INFICON STC-2002 Thin Film Deposition Controller Operating Manual - Manual (Page 169)

p STC-2002 DEPOSITION CONTROLLER y
SECTION 5.XX e page 167 of 276 ^
MEM: This allows you to save and exchange (swap) the I/O program that is in memory. A sub-
menu selects among 3 choices: SWP (SWAP), SAV (SAVE), and BAK (BACK 1 level).
Pressing the MEM (memory) key on the main menu (See Fig. 5.3) results in the
following screen. See section 5.10.
OPR:
This key (OPeRations) will start and stop the I/O program by means of a sub-menu
selection. Note: display changes to RUNNING when the RUN key is pressed and
STOPPED when the STP (stop) key is pressed.
There are times when the OPR function is
locked out during the I/O setup. Pressing the OPR (operations) key on the main I/O menu
(Fig. 5.10) results in the following.
See section 5.9.
EDT:
The EDT (edit) key is used to insert rungs, delete rungs and go on to enter or change
tokens/operators within a rung. This is the key that initiates the EDIT mode. The Edit
sub-menu offers: arrow cursors, GOTO, CHG (change), INS (insert line), DEL (delete
line) and BAK. Pressing the EDT (edit) key on the I/O Setup main menu (See Fig. 5.10)
results in the appearance of the I/O Setup Edit menu (see Fig. 5.11).
At this point, there are 3 selection keys available (navigation aside): one for an editing sub-menu (EDT),
another for an I/O program related memory option sub-menu (MEM), and a third for the operations control
sub-menu (OPR). (See Fig. 5.10 and screen immediately below)
Also at this point, the display will contain an EDIT(view) window into the I/O program. Specifically, three
consecutive rungs of the I/O program are displayed with the middle rung as the EDIT line (see figures 5.10
and screen immediately below). Each line of the I/O program is called a rung. Rung 004 is in the line edit
position with contents of "I81 #2 & O10" indicated by -
↓↓-. Rungs 003 and 005 are now view only. By
pressing the UP ↑ and DOWN↓ arrow keys on the LCD touch Panel, you can move through the I/O
program rung list bringing different rungs into view with middle line ready to edit. GOTO also navigates
by going directly to the entered rung number, making it the current rung in the EDIT window. BYE returns
to the EXECUTIVE MENU. The fixed STATUS key returns to the Run Time screen.
MEM (memory)
MENU
OPR
(operations)
MENU
Edit line#
[004: -↓↓-]
Edit rung
[I81 #2 & O10]
I/O MAIN
MENU