INFICON STC-2002 Thin Film Deposition Controller Operating Manual - Manual (Page 6)

p STC-2002 DEPOSITION CONTROLLER y
SECTION 1.XX e page 4 of 276 ^
Microbalance theory and thickness reading calibration with its attendant density, z factor (a material
reference table of elements is included) and tooling determination. Each section builds on the previous
sections such that no new elements are used that haven't been defined.
.
Some sage advice that is
seldom heeded.
.
SECTION 1.2 DESCRIPTION OF SYMBOLS
. note the following warning/safety/caution symbols [desc. of each] .
Please familiarize yourself with the following warning/safety/caution symbols found within this manual
and their general meaning:
Note: Highlights an important fact or condition.
Caution: Warns of a condition that could cause damage to deposition controller, connected or
associated equipment. Also warns if some action taken could result with an undesireable and/or
unexpected outcome.
or
!
: Warns of a condition that will likely cause damage to the deposition controller, connected or
associated equipment. Also warns of a possible unsafe situation for the user. Examples are static
sensitivities, maximum component ratings, broken fuses, etc.
or
: Warns of a condition that is hazardous to user, deposition controller, connected or associated
equipment.
Note
Caution
Static
Sensitive
Hazardous
Voltages
Present
You can lead a customer to water
but you can't make them read the
manual
.
If all else fails
read the manual
.