Xerox 7245 - Manual (Page 70)

70
NetBIOS over IP Peer to Peer Printing
D7
Before You Start
1. Obtain the Print Driver for your workstation's operating system. Drivers are available on one of the
CD-ROMs that came with your Device. They are also typically available for downloading in self-
extracting Zip file format from the Internet at www.xerox.com.
2. Print a Settings List as stated under the Network Connectivity Tab of this guide.
3. On the Settings List, verify that "SMB" is enabled. Also, verify that TCP/IP is enabled as one of
the supported protocols (NetBEUI may also be displayed). Verify that the workgroup's default
name is Workgroup
, or a valid, 15 character maximum, workgroup name. Also note the Device's
SMB Host Name (which assures the uniqueness of the Device's name within the Workgroup). To
enable "SMB," if required, follow the procedure stated under the Microsoft (NetBIOS over IP) item of
the NOS Selection menu, accessed from the Network Connectivity Tab of this guide. To modify the
name of the Workgroup, or Device's name (SMB Host name) within the workgroup, use your
workstation's Web browser to access the Internet Services (Web Pages) residing in the Device, as
described under the Configure SMB menu item, under the Internet Services Tab of this guide.
4. Make sure to configure the DNS/WINS Server(s) for NetBIOS name to IP address resolution. Then
provide the Device with the addresses of the Servers as stated in the Configure TCP/IP Settings
procedure of the Internet Services section of this guide.
Windows 95/98/Me Workstation Print Driver Installation
Verify that the Correct Protocols and Services are installed in the workstation
1. At the Workstation's Desktop, right-click the Network Neighborhood icon ("My Network Places" in
Windows Me) and select Properties.
2. On the Configuration Tab , verify that Client for Microsoft Networks is installed. If it is NOT, click
the Add button, select Client, select Add, select Client for Microsoft Networks, and click OK. If the
setup program fails to find the required files, you will have to click Have Disk… to load the client from
the Operating System installer disk for this workstation.
3. On the Configuration Tab , verify that the TCP/IP protocol is installed. If it is NOT, click the Add
button, select Protocol, select Add, select TCP/IP Protocol, and click OK. If the setup program fails
to find the required files, you will have to click Have Disk… to load the protocol from the Operating
System installer disk for this workstation.