Xerox 7245 - Manual (Page 166)

166
Installation Procedure
This section describes the configuration procedure to use the Scan to PC (FTP/SMB) feature on the
machine.
The following two steps are necessary to use the Scan to PC (FTP/SMB) feature.
• Enabling the required ports and Setting TCP/IP
Enable the FTP port and SMB port on the Device, and then set the machine’s IP address. If you will
be using SMB on a Microsoft Network, make sure to enable either DNS or WINS as part of the
TCP/IP configuration. For FTP, make sure that DNS is enabled.
• Preparing an FTP directory or SMB shared folder on the receiving computer (server or workstation).
Create an FTP directory or SMB shared folder to receive scanned documents over the network.