Novell netware 3.1x (bindery) networks b4, Enable the netware port at the device, Novell netware 3.1x (bindery) networks – Xerox 7245 User Manual
Page 51
51
Novell NetWare 3.1x (Bindery) Networks
B4
Enable the NetWare Port at the Device
1. Press
the
Log In / Out button
on the Control Panel.
2. Press
the
"1" key
on the numeric keypad five consecutive times. (This is the factory default
"password.")
3. Press the rectangular Confirm button on the touch screen.
4. Press
the
System Settings button
(the right-hand button of the two buttons displayed on the touch
screen). Note: If you press the left button by mistake, the Main menu will be displayed and you will
have to start over at step one above.
5. Press
the
System Settings button
.
6. Press
the
Network Settings button
.
7. Press
the
Port Settings button
to access the Port Settings menu.
8. Press
the
NetWare
selection line on the Port Settings menu.
9. Press
the
Change Settings button
in the lower right corner of the Port Settings menu screen.
10. When the NetWare selection menu displays, note that you have only one setting available on a
single, numbered horizontal line. Press this selection labeled Port Status.