Xerox 7245 - Manual (Page 26)

26
To Change the Alphanumeric Password used by Internet Services
Note: If Authentication is enabled, as stated in the Security – Authentication (by Auditron
Administration) topic in the Options section of this guide, you will have to supply the Administrator
User Name and Password when first accessing Internet Services, rather than supplying these
credentials after configuring individual features with Internet Services.
1. Press the Log In / Out button on the Device’s Control Panel.
2. Press the "1" key on the numeric keypad five consecutive times. This is the factory default
"password."
3. Press the rectangular Confirm button on the touch screen.
4. Press the System Settings button (the right-hand button of the two buttons displayed on the touch
screen). Note: If you press the left button by mistake, the Main menu will be displayed and you will
have to start over at step one above.
5. Press the System Administrator Settings button .
6. Press the System Administrator’s Password button .
7. Press the keyboard button, and use the displayed keyboard to enter in a new alphanumeric password
ranging from 4 to 12 characters in length.
8. Press the Save button.
9. Press the keyboard button, and use the displayed keyboard to enter in your new password a second
time and press Save again.
10. Press Save on the Password screen to save the new password.
11. To exit the System Administrator Settings screen, press the rectangular Close button in the upper
right corner of the screen.
12. Press the Exit button and the Device’s Main screen should now be displayed.