Xerox 7245 - Manual (Page 238)

238
Configuring a precise Bates Stamp location
1. Press the Log In / Out button on the Control Panel.
2. Press the "1" key on the numeric keypad five consecutive times. (This is the factory default
"password.")
3. Press the rectangular Confirm button on the touch screen.
4. Press System Settings .
5. Press System Settings again.
6. Press Copy Mode Settings .
7. Press Copy Control .
8. Press the down arrow to scroll to the Bates Stamping selection lines.
9. Press the applicable Bates Stamp position lines to set the precise location for your Bates stamp,
using x and y axes.
10. Press Change Settings to change settings.
11. Press Save to save your changes.
12. Press Close until the System Settings screen is displayed.
13. Press Exit on the System Settings screen to return to the Main (All Services) screen.