Xerox 7245 - Manual (Page 28)

28
Ethernet Setting (Ethernet Speed)
9. On the Protocol Settings menu, press the selection line labeled Ethernet Setting.
10. Press the Change Settings button.
11. On the settings screen, note which one of the buttons is highlighted as the current setting for Ethernet
Speed. The available settings are Auto (10 BASE-T/100 BASE-TX), 100 BASE-TX (Half or Full
Duplex), and 10 BASE-T (Half or Full Duplex). By default the Ethernet Port Configuration will be set
to Auto.
12. To change settings, press your setting of choice, then press the Save button.
13. To exit the screen, without making any changes, press the Cancel button.
Get IP Address (TCP/IP Addressing Method)
14. On the Protocol Settings menu, press the selection line labeled TCP/IP - Get IP Address.
15. Press the Change Settings button.
16. On the settings screen, note which one of the buttons is highlighted as the current setting for the
TCP/IP Addressing method. The available settings are DHCP, BOOTP, RARP, DHCP/Autonet, and
Manual. DHCP/Autonet is the factory default setting.
17. To change settings, press your selection of choice, then press the Save button.
18. To exit the screen, without making any changes, press the Cancel button.