Ipp configuration b14, To access ipp settings at the device, Ipp configuration – Xerox 7245 User Manual
Page 55
55
IPP Configuration
B14
The Internet Printing Protocol provides a convenient way to print over the Internet or Intranet using the
device's IP address. To support this type of printing, make sure that Port 9100 is enabled at the device
as stated in the Note at the bottom of the Configure Port 9100 procedure, in the Internet Services
section of this guide. Specifically, click the Port Status hot link on the Properties Tab of Internet Services
and make sure that the check box on the Port 9100 line is checked. The Internet Printing Protocol must
also be enabled at the device, and the Internet Print Service must be available and installed on the
individual desktop workstation's version of Windows. IPP support is already built into Windows 2000 and
XP. For other desktop operating systems it is available as a download from Microsoft at
tep is to install the IPP print driver, which is covered in the Print Drivers
section of this guide.
To access IPP Settings at the Device
1. Press the rectangular Log In / Out button on the Control Panel.
2. Press
the
"1" key
on the numeric keypad five consecutive times. (This is the factory default
"password.")
3. Press the rectangular Confirm button on the touch screen.
4. Press
the
System Settings button
(the right-hand button of the two buttons displayed on the touch
screen). Note: If you press the left button by mistake, the Main menu will be displayed and you will
have to start over at step one above.
5. Press
the
System Settings button
.
6. Press
the
Network Settings button
.
7. Press
the
Port Settings button
to access the Port Settings menu.
8. Press
the
IPP
selection line on the Port Settings menu.
9. Press
the
Change Settings button
in the lower right corner of the Port Settings menu screen.
10. When the IPP selection menu displays, note that you have two selections available on numbered
horizontal lines. The first selection is Port Status. The second is IPP – Added Port Number. The
Close button in the upper right corner of the screen returns you to the Port Settings menu. After
pressing the horizontal line selection, to access available settings press the Change Settings button
in the lower right corner of the touch screen.