Xerox 7245 - Manual (Page 294)

294
EtherTalk Troubleshooting
T7
Use the following check list to troubleshoot your network communication problem.
Check Physical Media and Network Interface Cards
1. Verify that the Device is powered ON.
2. Verify that the Device and Workstation are using the correct cabling to communicate over the
network. Use category 3 UTP patch (NOT crossover) cable for 10 Base T communications, category
5 UTP patch (NOT crossover) cable for 10 Base T / 100 Base TX communications, and Token Ring
cabling for Token Ring networks.
3. Verify that the cable at both the Device and Workstation is fully plugged into the Network Interface
Card (NIC). Check the link light, which is typically a green LED, to make sure that it is lit. Typically,
but not always, a second light on the Network Interface Card will be intermittently flashing, indicating
the presence of network traffic. If neither of these lights is lit, there is a problem with the NIC.
Print a Settings List at the Device and perform these tasks:
1. Under the Ethernet Settings data label on the Report, verify that your communications speed is
correctly set for your network and that you have a MAC address listed. The driver for your NIC works
at the Media Access Control (MAC) layer of the protocol stack. If no MAC address is shown, you
have either a bad NIC or no NIC at all. Replace or install the Network Interface Card.
2. Under the CentreWare Internet Services data label, verify that this feature is Enabled. If it is NOT,
enable it following the instructions supplied in the Network Connectivity section of this guide.
3. Under the EtherTalk data label, verify that the Port is enabled, and that Device has been assigned an
EtherTalk (Printer) name and an EtherTalk zone. If one or more of these parameters needs to be
configured, follow the instructions supplied in the EtherTalk (AppleTalk) Configuration topic of the
NOS Selection section of this guide.
4. Under the EtherTalk data label and at the bottom of the Settings List, verify that PostScript is
installed in the Device. If a PostScript license is installed in the Device, the PostScript logo will be
clearly displayed at the bottom of the Settings List. NOTE: If a PostScript license is NOT installed in
the Device, EtherTalk will NOT be displayed on the Settings List, and will be unavailable for
configuration using Internet Services. Consult your Xerox Representative for assistance.