Ethertalk (appletalk) configuration b7, To access ethertalk settings at the device, Ethertalk (appletalk) configuration – Xerox 7245 User Manual
Page 58
58
EtherTalk (AppleTalk) Configuration
B7
The EtherTalk Protocol enables workstation to Device communications over the EtherTalk (AppleTalk)
network.
To access EtherTalk Settings at the Device
1. Press
the
Log In / Out button
on the Control Panel.
2. Press
the
"1" key
on the numeric keypad five consecutive times. (This is the factory default
"password.")
3. Press the rectangular Confirm button on the touch screen.
4. Press
the
System Settings button
(the right-hand button of the two buttons displayed on the touch
screen). Note: If you press the left button by mistake, the Main menu will be displayed and you will
have to start over at step one above.
5. Press
the
System Settings button
.
6. Press
the
Network Settings button
.
7. Press
the
Port Settings button
to access the Port Settings menu.
8. Press
the
EtherTalk
selection line on the Port Settings menu.
9. Press
the
Change Settings button
in the lower right corner of the Port Settings menu screen.
10. When the EtherTalk selection menu displays, note that you have only one selection available on a
single, numbered horizontal line, with the current status of this setting shown. The Close button in the
upper right corner of the screen returns you to the Port Settings menu. After pressing the horizontal
line selection, to access available settings press the Change Settings button in the lower right corner
of the touch screen.