Xerox 7245 - Manual (Page 176)

176
5. Select Close repeatedly until the System Settings screen (with an Exit button) is displayed.
6. Select Exit .
7. If you changed any settings, the Device will automatically reboot to register and enable your new
settings. After the machine is restarted, print out a settings list to confirm that the ports are enabled
and TCP/IP is correctly configured.
For information on how to print a settings list, refer to the Settings List topic in the Network
Connectivity section of this guide.
Configuring the SNMP Port
Configure the transport protocol for the SNMP port using CentreWare Internet Services.
1. Start a web browser on a network connected workstation.
2. Enter the machine’s IP address in the address box of the browser and press Enter.
3. Click the Properties tab.
4. Click Port Status .
5. Select (place a checkmark in) the UDP check box next to SNMP.
6. Click Apply .
7. Enter the System Administrator user ID and password when prompted and click OK.
8. Click the Reboot button when it displays. If a Reboot button fails to display, click the Status tab and
click Reboot Machine from that screen.