Xerox 7245 - Manual (Page 19)

19
PJL (Printer Job Language)Setting
1. On the Parallel Port selections menu, press the selection line labeled PJL.
2. Press the Change Settings button.
3. On the settings screen, note which of the two buttons is highlighted as the current setting for Job
Control Language. This is the setting that enables the Controller's job processing parameters to be
modified by HP PJL. The available settings are Enabled or Disabled.
4. To change settings, press your setting of choice, then click the Save button on the touch screen.
5. To exit the screen, without making any changes, click the Cancel button on the touch screen.
Auto Eject time (Parallel Port Timeout)
1. On the Parallel Port selections menu, press the selection line labeled Auto Eject Time.
2. Press the Change Settings button.
3. On the settings screen, note the current display in seconds for the Parallel Port Timeout. This is the
length of time that the Controller will wait for an end of job command before printing the current job.
Up and down selection arrows are provided for modification of the timeout value in the increments
shown.
4. To change settings, use the up or down selection arrow, then click the Save button on the touch
screen.
5. To exit the screen, without making any changes, click the Cancel button on the touch screen.