Xerox 7245 - Manual (Page 283)

283
7. Under the NetWare data label, determine if the IPX Frame Type is set for Auto sensing (the factory
default). Other selections include Ethernet II (used when running TCP/IP on your network), Ethernet
802.3 (used for NetWare versions up to 3.11), Ethernet 802.2 (the default for NetWare 3.12 and
later), and Ethernet SNAP (used on networks running TCP/IP and/or AppleTalk). If the Frame Type
is not set to Auto sensing, or to the specific frame type used by the Primary Server, configure the
Device with the correct Frame Type following the instructions supplied in the Configure NetWare
Settings
procedure in the Internet Services section of this guide.
At the Windows workstation, perform these tasks:
1. At your 95/98/Me/NT workstation verify that the correct protocol and service is installed.
At the Desktop, right mouse click the Network Neighborhood icon ("My Network Places" in Windows
Me).
Left mouse click on Properties.
Click on the Protocols Tab (in Win. NT) or the Configuration Tab (in Win. 95/98/Me) to verify that
the IPX/SPX Protocol has been installed. It should appear in the displayed list.
Note: If the IPX/SPX Protocol has NOT been installed, click the Add button, select IPX/SPX Protocol
from the available list and click OK. If the setup program fails to find the required files, you will have
to click Have Disk... to load the protocol from the Operating System installer disk for this workstation.
Left mouse click on the Services Tab (in Win. NT) or the Configuration Tab (in Win. 95/98/Me) to
verify that the Microsoft Client for NetWare is installed.
Note: If the Microsoft Client for NetWare is NOT installed, click the Add button, select the Microsoft
Client Service (or Microsoft Network Service) for NetWare from the available list and click OK. If the
setup program fails to find the required files, you will have to click Have Disk... to load the service
from the Operating System installer disk for this workstation.