Xerox 7245 - Manual (Page 37)

37
Configure Port 9100 (Raw Printing)
B8
1. Open your Web browser and enter the TCP/IP address of the Device in the Address or Location field.
Press Enter.
2. Click the Properties Tab.
3. Click the plus (+) symbol to the left of the Protocol Settings file folder.
4. Select Port 9100 in the directory tree. (1)
5. The available selections include:
Port Number, with a default value of 9100. This value typically does not need to be changed.
A TBCP Filter checkbox (displayed when PostScript is enabled). Click Help for an explanation of the
use of this feature.
Connection Time-out Entry Box.
6. Enter a Time Out value for jobs being sent to the Device through this Port. This is the length of time
that the Controller will wait for an end of job command before printing the current job.
7. Click the Apply button to accept changes, or the Undo button to return settings to their previous
values. Note: Setting changes are not applied until you restart the Device.
(1) Note: If Port 9100 is NOT displayed in the Properties Tab directory tree, click the Port Status hot link
in the beginning list of hot links in the tree. In the Port Status table, use your mouse to place a check
mark in the checkbox on the Port 9100 line. Click the Apply button, then click the Reboot button (always
available on the Status Tab) to remotely reboot the Device.