Xerox 7245 - Manual (Page 29)

29
IP Address
1. Used for static IP Addressing (with "Manual" selected as your addressing method), on the Protocol
Settings menu, press the selection line labeled TCP/IP - IP Address. Note that the IP Address may
be viewed, but not changed, with dynamic addressing enabled.
2. Press the Change Settings button.
3. On the settings screen, use the rectangular Next key, together with the numeric keypad of the Control
Panel, to enter in the appropriate IP Address.
4. To save settings, press the Save button.
5. To exit the screen, without making any changes, press the Cancel button.
Subnet Mask
1. Used for static IP Addressing (with "Manual" selected as your addressing method), on the Protocol
Settings menu, press the selection line labeled TCP/IP - Subnet Mask. Note that the Subnet Mask
may be viewed, but not changed, with dynamic addressing enabled.
2. Press the Change Settings button.
3. On the settings screen, use the rectangular Next key, together with the numeric keypad of the Control
Panel, to enter in the appropriate Subnet Mask.
4. To save settings, press the Save button.
5. To exit the screen, without making any changes, press the Cancel button.
Gateway Address
1. Used for static IP Addressing (with "Manual" selected as your addressing method), on the Protocol
Settings menu, press the selection line labeled TCP/IP - Gateway Address. Note that the Gateway
address may be viewed, but not changed, with dynamic addressing enabled.
2. Press the Change Settings button.
3. On the settings screen, use the rectangular Next key, together with the numeric keypad of the Control
Panel, to enter in the appropriate Gateway.
4. To save settings, press the Save button.
5. To exit the screen, without making any changes, press the Cancel button.