N 7.3–1d: utility, 3–2: mfx 1 (master effect1), 3–3: mfx 2 (master effect2) – KORG TRITON STUDIO music workstation User Manual
Page 51: N 7.3–2(3)a: utility, 3–4: meq (master eq), N 7.3–4a: utility, 3–2: mfx 1, 3–3: mfx 2, 3–4: meq
PROG
1.1
2.1
2.2
2.3
3.1
4.1
4.2
5.1
5.2
5.3
6.1
6.2
6.3
6.4
7.1
7.2
7.3
41
■
7.3–1d: UTILITY
☞
“Write Program” (1.1–1c)
For details on how to select the desired utility function, refer
to “PROG 1.1–1c: UTILITY.”
Copy Master Effect
This command lets you copy any desired effect settings from
Program, Combination, Song or Song Play modes.
1
Select “Copy Master Effect” to access the dialog box.
2
In “From,” select the copy source mode, bank, and num-
ber.
You can use the Bank [A]–[G] keys to select the bank.
3
Select the effect that you wish to copy. If you select MFX
1
or 2, “Rtn (Return)” (return level) will be copied at the
same time. If you select Master EQ, only the master EQ
settings will be copied. You can also copy from an insert
effect. If you check “All,” all settings of the master effects
and master EQ will be copied.
If you copy from an insert effect the result may not be
identical, due to differences in routing and level set-
tings.
4
In “To,” select the copy destination master effect.
5
To execute the Copy Master Effect command, press the
[F8] (“OK”) key. To cancel, press the [F7] (“Cancel”) key.
Swap Master Effect
This command swaps (exchanges) the settings of MFX1 and
MFX2.
1
Select “Swap Master Effect” to access the dialog box.
2
To execute the Swap Master Effect command, press the
[F8] (“OK”) key. To cancel, press the [F7] (“Cancel”) key.
Select by Category
Selects master effects by category. (
This command can be used when selecting “Master
Effect 1,” ”Master Effect 2.”
7.3–2: MFX 1
(Master Effect1)
7.3–3: MFX 2
(Master Effect2)
Indicates effect parameter settings for the MFX1 and 2
effects that were selected in the Setup page (
(
p.227 “Dynamic Modulation Source (D.mod)”)
■
7.3–2(3)a: UTILITY
☞
“Write Program” (1.1–1c)
7.3–4: MEQ
(Master EQ)
The master EQ is a three-band stereo EQ. It is used to adjust
the overall tonality of the sound immediately before the L/R
bus is output to the AUDIO OUTPUT (MAIN OUT) L/
MONO and R jacks (
■
7.3–4a: UTILITY
☞
“Write Program” (1.1–1c)
7.3–2a
7.3–4a