1–2: route (routing), 1–2a: routing, N 7.1–2b: utility – KORG TRITON STUDIO music workstation User Manual
Page 48: Prog 7.2: ed–insertfx, 2–1: setup, 2–1a: insertfx setup, P.38), 1–2: route
38
Copy Insert Effect
This command copies effect settings from Program, Combi-
nation, Song, or Song Play mode.
1
Select “Copy Insert Effect” to access the dialog box.
2
In “From” select the copy source mode, bank, and num-
ber.
You can use the Bank [A]–[G] keys to select the bank.
3
Select the effect that you wish to copy. You can also copy
from a master effect. If “All” is checked, all effect settings
will be copied (i.e., the contents of the Setup page and the
effect parameters of IFX 1–5, but not “Ctrl Ch”).
If you are copying from a master effect, the result may
not be identical, due to differences in the routing and
level settings of a master effect.
4
In “To,” select the copy destination insert effect. If you
check
“Post IFX Mixer Setting,” the “Chain,” “Pan
(CC#8),” “BUS Select,” “S1 (Send 1 (MFX1))” and “S2
(Send 2 (MFX2))” settings that follow the copy source
insert effect will also be copied. If you do not check this,
only the effect type and its parameters will be copied.
5
To execute the Copy Insert Effect command, press the
[F8] (“OK”) key. To cancel, press the [F7] (“Cancel”) key.
Swap Insert Effect
This command swaps (exchanges) insert effect settings.
1
Select “Swap Insert Effect” to access the dialog box.
2
In “Source 1” and “Source 2,” select each of the insert
effects that you wish to swap.
3
To execute the Swap Insert Effect command, press the
[F8] (“OK”) key. To cancel, press the [F7] (“Cancel”) key.
7.1–2: Route
(Routing)
7.1–2a: Routing
This displays the setting status of the insert effects.
This shows the insert effect routing, the names of the
selected effects, their on/off setting, and chain status. The
insert effect type, on/off, and chain settings can be made in
the Setup page of 7.2: Ed-InsertFx.
You can use the Value Controller to set “BUS Select” (
☞
7.1–
1a).
■
7.1–2b: UTILITY
☞
“Write Program” (1.1–1c), “Copy Insert Effect,” “Swap
Insert Effect” (7.1–1c)
7.2–1: Setup
Here you can select the type of each insert effect, turn it on/
off, and make chain settings.
The direct sound (Dry) of an insert effect is always stereo
input and output. The input/output of the effect sound
(Wet) will depend on the effect type (
7.2–1a: InsertFX Setup
IFX1 — IFX5 On/Off
[Off, ON]
Selects the insert effect on/off.
When this is Off, the input will be output without change.
(For 000: No Effect, on/off will produce the same result.)
PROG 7.2: Ed–InsertFX
7.1–2a
7.1–2b
7.2–1a
7.2–1b